Free on-site gate assessment - hinges, posts, and your LiftMaster or Nice gate operator checked before anything is quoted
The assessment is free and the quote is the invoice.
Before
After
Before
After
Before
AfterFAAC Gate Access Control in University Park: What to Know First
We’re an independent FAAC service provider in University Park, and we handle gate access control work on FAAC systems most days of the week. A typical keypad, entry, or phone-entry repair on a FAAC opener is diagnosed and fixed in a single visit, usually within two to four hours on site. Pricing is settled before we turn a single bolt, and our written 90-Day Done Right Promise covers every job. This page is for University Park homeowners who own a FAAC gate and want a straight answer about what’s wrong and what it costs to make it right. Call (936) 259-0479 any hour, any day, and a live person answers.
How FAAC Products Fail - and How We Fix Them
FAAC builds a solid opener. But gate access control components fail in predictable ways, often for reasons the manufacturer’s manual won’t tell you. Here’s what we see in University Park.
- FAAC 400 Series with radio interference on the 433 MHz band. The 400 and 402 control boards are workhorses, but the receiver circuits are sensitive to nearby ham radio operators, airport radar scatter from Dallas Love Field, and even some home security systems. A homeowner notices the remote works from ten feet away but not from the street. We shield the antenna, reposition it, or swap in a receiver with tighter filtering. Rarely needs a new board.
- FAAC E024S keypad membrane going dead after Dallas summers. The E024S is a coded keypad overlay that sits on the gate post, exposed to Texas sun. After three or four summers, the membrane delaminates and keys stop registering. It’s not the control board. We replace the membrane or the keypad unit, re-seal the housing, and move on. Twenty minutes, in most cases.
- FAAC 750 and 760 gate operators losing limit settings. These are powerful 24-volt operators for heavier gates. When the limit switches drift, the gate opens halfway and reverses, or slams at the end of travel. Some crews replace the motor. We recalibrate the limit cams and check the encoder. If the cam follower is worn, we replace that small part, not the operator.
- FAAC photocell misalignment on University Park alleys. The FAAC photocells installed on driveway gates near service alleys get bumped by mowers, trash bins, and landscape crews. When misaligned, the gate won’t close or reverses mid-cycle. We realign, shim, and seal the mounting brackets so they stay put. It’s a five-minute fix that some companies bill as a two-hour diagnostic.
- Phone entry and intercom systems that worked fine until a power surge. FAAC’s phone entry modules and video intercoms are sensitive to the power dips we get in University Park during summer thunderstorms. After a surge, the module powers up but won’t dial. We test the surge protection, replace the module if needed, and add inline surge suppression so the next storm doesn’t repeat the failure. An FAAC dealer won’t always tell you surge protection is a separate, inexpensive install. It is, and we do it as a matter of course.
Our FAAC Gate Access Control Process
Victor Salinas grew up in Oak Lawn and has spent the better part of three decades working gates across University Park. The process we follow on a FAAC access control job is the same one he learned at Eastfield College, where a shop instructor told him early on that a gate is only as honest as the person who fixes it. Here’s how it works.
- 1
You call, we answer. A live person picks up at (936) 259-0479, any hour. You tell us what the gate is doing. Tell me what it is doing, and I will tell you what it needs - no more, no less.
- 2
Diagnostic visit. Our tech arrives in a marked truck, uniformed and background-checked. We test the access control device, the wiring, the control board, and the operator itself, because half the time the problem isn’t where the homeowner thinks it is.
- 3
Upfront pricing. Before we change a part or run new wire, you get a written price. You approve it or you don’t. No surprises on the bill, ever.
- 4
The repair. Parts decision is made with you. Genuine FAAC parts where the job calls for it, or a quality aftermarket equivalent that fits FAAC specs when it’s the honest, lower-cost choice that won’t compromise the gate’s operation.
- 5
Testing and proving. We cycle the gate ten to fifteen times, test every access point, every remote, every keypad code. We don’t leave until it works reliably from the street, the driveway, and the house.
- 6
The 90-Day Done Right Promise. Every job is backed in writing. If it’s not right, we come back and make it right. No paperwork, no arguing.
What FAAC Gate Access Control Costs in University Park
Here’s what we charge for common FAAC access control scenarios, in plain numbers.
- Keypad replacement or repair (FAAC E024S or similar): $195 to $420 installed, depending on model and whether we need to run new low-voltage wire from the keypad to the control board.
- Remote control programming and receiver repair: $120 to $260, including new remotes if needed. Reprogramming an existing system without parts runs toward the low end.
- Phone entry system installation on a FAAC gate: $650 to $1,400, depending on whether it’s a simple dial-to-open module or a full video intercom with a house station.
- Photocell alignment or replacement: $90 to $220. Most realignments are under $150.
- Full diagnostic visit with no repair: $89, which we credit toward the repair if you proceed the same day.
What moves the price is access. A keypad on a masonry pillar with existing conduit is a simple job. A phone entry system that needs trenching across a stamped concrete driveway is not. Either way, the price is quoted and agreed before any work starts. Call (936) 259-0479 for an exact quote. Estimates are free.
Why University Park Homeowners Call Ironworks Gate Co. for FAAC Work
We’ve been at this since 1984. That’s over 42 years of gates in University Park, Highland Park, Preston Hollow, and the neighborhoods around them. Our techs are trained and equipped on nine gate-automation brands, so a FAAC job gets the same precise treatment as a LiftMaster, Mighty Mule, Ghost Controls, or DoorKing job. If we find something unexpected on a FAAC board, we know the wiring and logic well enough to work around it without guessing. Most FAAC access control repairs are finished in one visit. And every one of them carries our written 90-Day Done Right Promise. If it’s not right, we come back. That’s the Keystone Standard, and it applies to the 400th job the same as the first.
FAQs
As an independent FAAC service provider, we are not a factory-authorized dealer, but we are trained and equipped on FAAC equipment. If your FAAC system is still under factory warranty, we recommend you check the warranty terms. For out-of-warranty work, which is most of what we see in University Park, our repairs don’t affect any remaining manufacturer coverage because there typically isn’t any. Our own 90-Day Done Right Promise covers our work regardless.
Most FAAC access control jobs are scheduled within one to two business days, and emergency calls for a gate stuck open or closed are handled around the clock. A live person answers at (936) 259-0479 any hour, and we’ll tell you honestly when we can be there. Call before noon on a weekday and we can often get a tech out the same day.
We keep common FAAC access control parts on our trucks: keypads, receivers, photocells, capacitors, and control board components. Less common items like a full 750-series control board or a phone entry module may need to be ordered, usually arriving in two to four business days. We’ll tell you which situation you’re in before we quote anything, so you aren’t waiting on a surprise parts order.
If the operator itself is sound and the failure is in the keypad, receiver, or wiring, repair is almost always the honest choice, and that’s what we recommend. If the control board has failed twice in two years, or the operator is over fifteen years old and chewing through parts, we’ll tell you that too. We are not in the business of selling replacements when a repair is the right call. Call (936) 259-0479 and we’ll tell you straight what your gate needs.
Emergency FAAC access control calls, especially a gate stuck open with no way to secure it, get priority routing any hour of the day. Call (936) 259-0479 and a live person will tell you whether we can have a tech in University Park today. If it’s a non-emergency, we’ll give you the next available window and we’ll be there when we say.
Call Ironworks Gate Co. for FAAC Gate Access Control in University Park
If your FAAC keypad is dead, your remote won’t reach the gate from the street, or your phone entry module stopped dialing, call us at (936) 259-0479. We’ll answer the phone, schedule a diagnostic, and give you an upfront price before any work starts. Free estimates. Free second opinion on any written estimate from another company. And the 90-Day Done Right Promise on every job. Done right, and backed in writing.
Written by Victor Salinas, Owner & Gate Repair Specialist, Ironworks Gate Co. at Ironworks Gate Co., serving University Park and nearby areas.